What does this mean?
Interpretation of OBD2 Code P0480 Jeep:
The electric fan controller is controlled by a powertrain control module (PCM) via cooling cooling equipment based on inputs from the following components: – Cooling engine sensor (ECT) – Air temperature sensor (IAT) – The A / C sensor – Machine A / C refrigerator runners – Vehicle Transmission System (VSS) PCM controls the cooling fan by installing a cooling system that turns on the heating device. Extras give you the power to receive when the following conditions are met: – Engine temperature up to 106¡ãC (223¡ãF) or more. – The clutch A / C requested. – Vehicle speed is less than 38 MPH. The cooling fan emitter will be controlled AS SOON as the car’s speed is achieved: – Engine temperature is 151¡ãC (304¡ãF) or higher. – A / C pressure for refrigerant is high. The propeller monitor can be controlled ON the engine when it runs under the controls described in the electronic description section.
Possible indicators of OBD code P0480 Jeep
– Engine Light ON (or Service Engine Soon Warning Light) – Engine temperature
What may cause the code OBD P0480 Jeep
– A fan connecting cable – A connector connecting fan and a fan – A control connector fan – Heat of the fan 1 The error code is usually opened by noting the following: P0481 Jeep code is detected when PCM detects that the driver is in control of the actual state of the control unit.
– Change the reception for non-performing fans 1 – Restore cool cooling 1